YG Machinery has a series of hot-selling portable water well drilling rigs. Because the portable well drilling rig is low in cost, convenient to move, and cost-effective. It is suitable for home drilling water wells and other small drilling projects. Check the following portable water drilling machine parameters.
How to maintain portable water well drilling rigs?
Before the start-up of the portable water well drilling rigs, the high-pressure gas is led into the air chamber through the control valve in sequence through the handle body. The disc-type valve alternately guides the gas into the front and rear chambers of the cylinder block, thus driving the piston to make high-speed round-trip action. And the remaining gas is discharged from the muffler cover. Contact us to get portable water well-drilling rigs’ price now.
Before using the new portable well drilling rig, disassemble and clean the internal parts and cleaned, and remove the antirust grease applied to the machine when leaving the factory. After cleaning, repaint the surface of each part with lubricating oil. When using it, operate it under low pressure (0.3MPa) or half-started state for 10 minutes, and then it can work normally. Contact us to get more portable water well-drilling rig details.
The air pressure of the air supply pipe of the small water well drilling rigs should be within the range of 0.5-0.6mpa. If the air pressure is too high, it is easy to damage the parts. If the air pressure is too low, the drilling efficiency will decrease obviously, which will lead to the failure of the small well drilling rig.
Keep air supply pipe clean
Before connecting the air supply pipe of the portable water well drilling rigs with the rock drill, blow the dirt in the air pipe first, so as to prevent the dirt from blowing into the body, causing valve plate failure and damaging parts. After connecting the gas and water, check whether the threaded connection parts are tight before starting the machine, and then start the machine formally. As a professional portable water well drilling rigs manufacturer, we are happy to answer your question about small water well drilling rigs for sale.
After the portable water, well drilling rigs are started, first check whether the atomization condition of the oil mist atomizer is appropriate and adjust it well. During the operation, fill the oil mist atomizer every 1 hour, and do not work without lubrication. Leave your message to get a water well drilling machine price.
When the drilling machine starts, start the drilling machine should in the middle operation. When gradually increasing the propulsion force of the air leg, the drilling machine can start at full speed. It is not allowed to open the full operation when the air leg thrust is maximum, which may cause the whole machine to be stuck. And it is not allowed to run at full speed for a long time to avoid parts wear. If you want to buy a cheap water well drilling machine for sale, please leave your message.
Portable electric folding type water well drilling rig factory
When the portable water well drilling rigs finish drilling and pulling out the drill rod, carrying out at a medium speed. If the drilling machine stops drilling anymore, remove the water pipe and blow the residual water stains inside the machine to prevent corrosion of internal parts. If you have any questions about YG water well drilling equipment for sale, please feel free to tell us.
We use cookies to ensure that we give you the best experience on our website. If you continue to use this site we will assume that you are happy with it.Ok
